valve clearences
Submitted: Monday, Sep 08, 2003 at 19:46
ThreadID:
7112
Views:
1384
Replies:
5
FollowUps:
3
This Thread has been Archived
Anton
Hi Guys
I have 99 mod hilux 2.7 petrol and was wondering if anyone out there would know what the exhaust and intake valve clearences were???
Reply By: Member - Robert (WA) - Monday, Sep 08, 2003 at 20:29
Monday, Sep 08, 2003 at 20:29
will get them for you tomorrow morning
AnswerID:
30492
Reply By: Member - Robert (WA) - Tuesday, Sep 09, 2003 at 09:03
Tuesday, Sep 09, 2003 at 09:03
if it is a 3RZ-FE motor the tappets clearances are
IN 0.15 to 0.25 mm cold
EX 0.25 to 0.35 mm cold
good luck
Robert
AnswerID:
30554
Follow Up By: Anton - Tuesday, Sep 09, 2003 at 15:28
Tuesday, Sep 09, 2003 at 15:28
Cheers Robert
FollowupID:
21615
Reply By: Anton - Wednesday, Sep 10, 2003 at 13:14
Wednesday, Sep 10, 2003 at 13:14
Hi robert
thanks for the info on the tappet clearences. Just one last question, do you know if the hilux 2.7 petrol is suppost to run an oxy sensor
AnswerID:
30673
Follow Up By: Anton - Wednesday, Sep 10, 2003 at 13:18
Wednesday, Sep 10, 2003 at 13:18
sorry the type O (SUPPOST)
FollowupID:
21698
Reply By: Member - Robert (WA) - Wednesday, Sep 10, 2003 at 19:05
Wednesday, Sep 10, 2003 at 19:05
It should have a oxy sensor on the exhaust before the cat convertor hope this helps
Robert
AnswerID:
30707
Follow Up By: Anton - Thursday, Sep 11, 2003 at 08:54
Thursday, Sep 11, 2003 at 08:54
That's the thing Robert it doesn't seem to have an oxy sensor or a cat.
I was told commercial vehicles such as the hilux do not run a cat.
Is this true!!! As for the oxy sensor I have searched high and low but it doesn't seem to be there....
FollowupID:
21752
Reply By: Member - Robert (WA) - Thursday, Sep 11, 2003 at 09:00
Thursday, Sep 11, 2003 at 09:00
will try and find out
AnswerID:
30750