350 Holley to Nissan P40 engine
Submitted: Thursday, Jan 13, 2005 at 17:44
ThreadID:
19333
Views:
4612
Replies:
2
FollowUps:
2
This Thread has been Archived
Leo53
Hello All,
I need some input regarding adapting a 2300 series 350 Holley carb to my Nissan P40 engine.
If anyone knows where I could get an adapter and jetting advise it would be appreciated.
Regards
Leo53
Reply By: Member - Chrispy (NSW) - Thursday, Jan 13, 2005 at 18:04
Thursday, Jan 13, 2005 at 18:04
Leo - can't be of help (technically) I'm sorry..... but this engine should go like stink with a Holley. I presume it's still in a G60?
The P40 was (I believe) originally built for Nissan forklists, and as such has oodles of low-end torque....
Nice!!
AnswerID:
92853
Follow Up By: Leo53 - Thursday, Jan 13, 2005 at 19:45
Thursday, Jan 13, 2005 at 19:45
Thanks Chrispy,
Actualy it`s in a `84 MQ Wagon, I just want to be able to get spares for the carb a little easier as the kits I`ve bought for the original are not upto scratch.
Regards
Leo53
FollowupID:
351813
Reply By: David Au - Thursday, Jan 13, 2005 at 19:25
Thursday, Jan 13, 2005 at 19:25
If anybody has the parts off the shelf you need then Lynx Corp will have.
It does not matter what you do to the P40 it will not improve fuel consumption.
You can put any carburettor, extractors, 300mm exhaust stacks or anything else on the P40 and it will stay the same fuel consumption.
AnswerID:
92867
Follow Up By: Leo53 - Thursday, Jan 13, 2005 at 19:48
Thursday, Jan 13, 2005 at 19:48
Thanks David Au
I`ll follow that with Lynx Corp. I`m not too worried about the fuel consumption because it`s still a lot less than one of the newer petrol 4x4`s. I`ve got a 120lt tank and a 5 speed so it should be OK.
Regards
Leo53
FollowupID:
351815